Your garage door won't open and the car is inside: what to check

Four quick checks, a symptom table, and a plain answer on when it is safe to get the car out yourself and when it is not.

Published

Car parked inside a garage facing a closed sectional garage door

If your garage door won’t open, check four things first: power, the wall-control lock, the remote, and the spring above the door. A gap in the spring coil means it has broken. If the spring is broken, do not lift the door or pull the red release cord.

Four checks that take two minutes

  1. Power. Press the wall button and watch the opener on the ceiling. No light and no sound means no power. See that it is plugged in, then check the breaker and any GFCI outlet in the garage. A tripped GFCI has a popped button you can press back in.
  2. The lock on the wall control. Many wall controls have a lock or vacation setting that makes the opener ignore remotes. If the wall button works and the remotes do not, suspect this. The manual shows how to turn it off.
  3. The remote. If one remote works and the other does not, the dead one needs a battery.
  4. The spring. Stand inside and look at the wall above the door. A torsion spring is a tight coil on a steel shaft. A broken one has a gap of an inch or two. If you see that, stop here and go to emergency garage door repair.

Match what you see to the cause

What you see Likely cause Safe to try yourself When to call
Nothing happens at all No power, tripped GFCI, lock mode or a dead remote battery Yes. The four checks above The opener has power and still ignores the wall button
Opener runs, door stays put Trolley disconnected from the door, or a stripped gear inside the opener With the door fully closed, reconnect the trolley, following the manual The motor runs and the chain or belt does not move
Door lifts a few inches and stops Broken spring No Now
Door is crooked, one side higher A cable has come off or snapped No Now
You heard a loud bang earlier A spring broke No Now
The power is out Opener has no electricity Battery backup, or the manual release with the door fully down The door feels heavy by hand

If the opener is the problem

If the motor runs and the chain or belt moves but the door sits still, the opener has lost its connection to the door. If it only hums, stop: that points to a spring or a gear, and it needs a technician. For a lost connection, look at the trolley, the carriage that rides the rail and holds the arm to the door. If someone pulled the red cord, the trolley is disengaged, and the opener is moving nothing. Your manual shows how to latch it again with the door closed.

If the trolley is connected and the motor runs with no movement in the chain or belt, a drive gear inside the unit has probably stripped. That is a parts job. ServiceMagic’s San Diego figures put the average opener repair at $254, with a typical range of $125 to $346, and the technician quotes before starting. The garage door opener repair page covers repair against replacement.

If the door is the problem

The opener is a small motor. It moves the door only because the springs carry the weight. When a spring breaks, the door goes from light to its full weight, commonly 130 to 350 pounds, and the opener gives up after a few inches. A bang from the garage earlier in the day, or overnight, is often the first clue.

A door that hangs crooked points to a cable. One side has lost its lift and the other is still pulling. Running the opener in that state can twist the door out of its tracks.

Broken spring or loose cable Leave the door down. Do not lift it, do not keep pressing the button, and do not pull the red release. Unplug the opener if you can reach the cord without walking under the door, or switch off its breaker. Keep children away from slack cables.

Both jobs belong to a technician with the right bars and clamps. See garage door spring repair and cable repair for what each one involves.

Getting the car out

When you can try. The spring is intact, the cables are tight on both sides, and the door sits level. In that case the trouble is the opener or the power. With the door fully closed, pull the red release cord and lift from the handle or bottom edge. A balanced door comes up with modest effort and stays open. Raise it all the way, drive out, lower it by hand, and lock it from inside if it has a slide lock. Unlock it before you reconnect the opener.

When to stop. The door feels heavy in the first few inches. Set it back down. That weight means a spring is weak or broken even if you cannot see the gap.

When not to start. You can see a gap in the spring, a cable is slack, or the door is crooked. Propping a door like that on a ladder or a length of lumber is how people get hurt. A technician can raise and secure it properly. Call any hour and say the car is trapped.

Power cuts and fire weather

A power cut during fire weather is the worst time to learn how your door opens by hand. The State Fire Marshal’s 2025 map puts 8,170 acres of Carlsbad in the Very High fire hazard zone.

California has required battery backup on residential openers sold or installed since July 1, 2019. If yours is older, find the red cord today and try the release once with the door down. Our post on the battery backup law explains how to test a backup.

What a technician is needed for

Power, lock mode, remote batteries and a disengaged trolley are yours to fix. Springs, cables, bottom brackets, a stripped opener gear and a door out of its tracks are not, because each one involves either stored tension or the full weight of the door.

The line is answered 24 hours a day, and same-day service is available across Carlsbad. Tell us what the door is doing and whether a car is stuck inside, and we’ll get a licensed local technician out. You hear the price before work begins. Start at emergency garage door repair.

Common questions

My garage door spring broke. How do I open the door?

You do not, by yourself. With a broken spring the door is dead weight, commonly 130 to 350 pounds, and neither you nor the opener should lift it. Pulling the red release does not help, because the spring was doing the lifting. A technician can raise and secure the door safely so the car can come out, then replace the spring.

Why won't my garage door open with the remote when the wall button works?

Start with the remote's battery. If every remote stopped at once, the wall control is probably in lock mode, which tells the opener to ignore remotes. Your opener manual shows how to switch the lock off. If neither is the cause, the opener's receiver may be at fault, and that is an opener repair.

Why does my garage door open a few inches and then stop?

That is the usual sign of a broken spring. The opener starts the lift, meets the full weight of the door, and its safety logic stops it. Look above the closed door for a gap in the coil. Do not keep pressing the button. Each attempt strains the opener gear and can pull a cable off its drum.

How do I open my garage door when the power is out?

If the opener has a battery backup, press the wall button as usual. If it does not, make sure the door is fully closed, pull the red release cord, and lift the door by hand. It should feel light. If it feels heavy, set it down and stop, because that means a spring problem.

Garage door trouble in Carlsbad?

Tell us what the door is doing and we will get a local technician on it.

Call (760) 230-5812Request service